Call Now

RV Rooftop AC Replacement - Daytona Beach, FL

RV Repair Daytona Beach replaces failed or end-of-life rooftop AC units at your location - no shop visit needed. We remove the old unit, inspect and seal the roof penetration, and install a new Dometic Penguin II, Coleman Mach 8, or equivalent unit matched to your RV's BTU requirements. Most single-zone rooftop replacements are completed in 3-4 hours, including electrical reconnection and a full cool-down test.

Call (386) 555-0100 Request Callback
Same-Day Service
|
All Volusia County
|
Licensed & Insured

Choosing the Right Replacement Rooftop AC for Your RV - BTU, Voltage, and Ceiling Assembly Compatibility

RV technician diagnosing AC electrical panel
RV technician diagnosing AC electrical panel

Selecting a replacement rooftop AC unit requires matching three specifications: BTU output, voltage configuration (115V single-phase for most units), and ceiling assembly compatibility. Dometic Penguin II units are available in 13,500 and 15,000 BTU configurations, and the ceiling assembly - ducted or non-ducted - must be specified at the time of order because they are not interchangeable with Coleman Mach ceiling kits. Coleman Mach 8 units come in standard and heat pump variants; ordering the wrong variant means a second trip.

Advent Air units are a less common but fully serviceable option we also stock. Our technicians verify your existing ceiling assembly type, the roof cutout dimensions, and your shore power service capacity before ordering the replacement unit - a 15,000 BTU heat pump draws up to 15 amps on startup and will nuisance-trip a 20-amp branch circuit on a 30-amp service if the rig already has moderate loads running.

How a Rooftop AC Replacement Proceeds On-Site

Mobile RV repair technician on-site
Mobile RV repair technician on-site

Our two-technician rooftop replacement process begins with protecting the roof surface from foot traffic damage and staging the new unit on the ground for pre-installation inspection. The old unit is disconnected from the 120V supply, the interior ceiling assembly is unbolted from below, and the bolts securing the rooftop unit are removed from the roof surface. The old unit is lowered off the roof, and the curb board is inspected for rot or water saturation - soft curb material is treated with wood hardener or replaced with marine-grade plywood before the new unit is installed.

The old foam gasket is fully removed, and a new manufacturer-spec gasket is seated in the curb before the new unit is positioned. Bolts are torqued to spec from below, the 120V connection is made, and the system is run through a full cooling cycle to verify the temperature differential reaches at least 16 degrees Fahrenheit at the supply register before we leave the site.

RV Air Conditioning Repair Cost in Daytona Beach, FL

ServiceTypical CostNotes
Service Call + First Hour$299 - $399Travel + diagnostics anywhere in Volusia County
Start / Run Capacitor Replacement$150 - $300Most common AC failure, same-day fix
Refrigerant Recharge$200 - $500R-410A systems; technician
Blower Motor Replacement$250 - $450Includes labor; part sourced from truck stock
Rooftop AC Unit Replacement$1,200 - $2,800Dometic / Coleman Mach; 3-5 hr installation
Thermostat Replacement$100 - $200Includes digital thermostat and wiring
Compressor Replacement$800 - $2,000Full rooftop disassembly required

Pricing note: Ranges shown are average costs for the Daytona Beach, FL market based on common repair scenarios. The exact cost of your repair depends on your RV make and model, the severity of the issue, and parts availability.

Only a technician on-site can provide an accurate estimate after inspecting your RV. A written estimate is provided before any work begins - you approve it before we start.

RV Rooftop AC Replacement - Common Questions

What rooftop AC brands and models do you install?

We stock and install Dometic Penguin II, Coleman Mach 8, and Advent Air units covering 13,500 BTU and 15,000 BTU configurations. If your rig uses a less common unit, we source the correct replacement before scheduling the appointment so we are not making a second trip.

Does the roof gasket get replaced during a rooftop AC swap?

Yes - the foam gasket between the unit and the roof is replaced on every installation. A cracked or compressed old gasket is a primary source of water intrusion and we never reuse it regardless of its apparent condition.

Can you replace just the rooftop air handler and keep the interior ceiling assembly?

In most cases, yes - the interior ceiling assembly (ducted or non-ducted) can be retained if it is in good condition and mechanically compatible with the new unit. We verify compatibility before the job so you are not paying for parts you do not need.

What is the typical cost range for a rooftop RV AC replacement?

The total cost depends on the unit specified - a 13,500 BTU non-ducted Dometic Penguin II is the most affordable entry point, while a 15,000 BTU Coleman Mach heat pump with a ducted ceiling kit is at the higher end. Labor for a single-zone replacement with a standard curb board runs two to three technician hours. We quote parts and labor separately so you can see what you are paying for.

Can I keep my existing interior ceiling assembly when replacing the rooftop unit?

In most cases yes, provided the ceiling assembly is in good condition and mechanically compatible with the new rooftop unit. Dometic-branded ceiling assemblies are matched to Dometic rooftop units, and Coleman Mach assemblies match Coleman Mach rooftops - cross-brand swaps require an adapter kit or a full ceiling assembly replacement. We verify compatibility before quoting the job to avoid surprises on installation day.

Need RV Rooftop AC Replacement in Daytona Beach?

Same-day service available. Written estimate before any work starts.